Since pmu-fw release 2018.3, the ZYNQMP_FPGA_BIT_ONLY_BIN flag is no
longer used. This wasn't a problem for a while, but in newer versions a
validation sequence will fail if this flag is set. This means that the PL
can no longer be loaded.
Do not set the ZYNQMP_FPGA_BIT_ONLY_BIN flag unless absolutely necessary
to avoid this problem.
Signed-off-by: Matthias Fend <matthias.fend@xxxxxxxxx>
---
drivers/firmware/zynqmp-fpga.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/firmware/zynqmp-fpga.c b/drivers/firmware/zynqmp-fpga.c
index 63d7398fd..db34ac2be 100644
--- a/drivers/firmware/zynqmp-fpga.c
+++ b/drivers/firmware/zynqmp-fpga.c
@@ -261,9 +261,10 @@ static int fpgamgr_program_finish(struct firmware_handler *fh)
goto err_free_dma;
}
- if (mgr->features & ZYNQMP_PM_FEATURE_SIZE_NOT_NEEDED)
+ if (mgr->features & ZYNQMP_PM_FEATURE_SIZE_NOT_NEEDED) {
+ flags &= ~ZYNQMP_FPGA_BIT_ONLY_BIN;
buf_size = body_length;
- else
+ } else
buf_size = addr + body_length;
status = mgr->eemi_ops->fpga_load((u64)addr, buf_size, flags);
--
2.25.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
