From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx> New Hardware revision swapped the gmacs (wan is now gmac1). Previous Revision (v00) was not in public sale so devicetree can be savely changed. Signed-off-by: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx> --- arch/arm/dts/rk3568-bpi-r2-pro.dts | 28 ++++++++++++++-------------- 1 file changed, 14 insertions(+), 14 deletions(-) diff --git a/arch/arm/dts/rk3568-bpi-r2-pro.dts b/arch/arm/dts/rk3568-bpi-r2-pro.dts index ef2e0c33e663..cc1bab37074a 100644 --- a/arch/arm/dts/rk3568-bpi-r2-pro.dts +++ b/arch/arm/dts/rk3568-bpi-r2-pro.dts @@ -120,20 +120,20 @@ }; }; -&gmac0 { - assigned-clocks = <&cru SCLK_GMAC0_RX_TX>, <&cru SCLK_GMAC0>; - assigned-clock-parents = <&cru SCLK_GMAC0_RGMII_SPEED>, <&cru CLK_MAC0_2TOP>; - assigned-clock-rates = <0>, <125000000>; - clock_in_out = "input"; - phy-handle = <&rgmii_phy0>; +&gmac1 { + assigned-clocks = <&cru SCLK_GMAC1_RX_TX>, <&cru SCLK_GMAC1>; + assigned-clock-parents = <&cru SCLK_GMAC1_RGMII_SPEED>, <&cru CLK_MAC1_2TOP>; + clock_in_out = "output"; + phy-handle = <&rgmii_phy1>; phy-mode = "rgmii"; pinctrl-names = "default"; - pinctrl-0 = <&gmac0_miim - &gmac0_tx_bus2 - &gmac0_rx_bus2 - &gmac0_rgmii_clk - &gmac0_rgmii_bus>; - snps,reset-gpio = <&gpio3 RK_PB7 GPIO_ACTIVE_LOW>; + pinctrl-0 = <&gmac1m1_miim + &gmac1m1_tx_bus2 + &gmac1m1_rx_bus2 + &gmac1m1_rgmii_clk + &gmac1m1_rgmii_bus>; + + snps,reset-gpio = <&gpio3 RK_PB0 GPIO_ACTIVE_LOW>; snps,reset-active-low; /* Reset time is 20ms, 100ms for rtl8211f */ snps,reset-delays-us = <0 20000 100000>; @@ -367,8 +367,8 @@ status = "disabled"; }; -&mdio0 { - rgmii_phy0: ethernet-phy@0 { +&mdio1 { + rgmii_phy1: ethernet-phy@0 { compatible = "ethernet-phy-ieee802.3-c22"; reg = <0x0>; }; -- 2.25.1 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox