I am working on a LS1021A currently booting from SPI NOR. I am having difficulties to get the network port working. Issue is that the PHY AR8033 is not initialized properly and even though I get the correct speed/duplex at first (1000FD), no data go through. Clearing/writing 0x100 to the phy control register then gives the lowest speed/duplex(10HD) and ping works. The at803.c phy driver is now enabled but I do not see the driver probe function being called and neither mdio_bus_match. I see a few examples of device trees to add the properties found in the driver. What else am I missing for the at803 to be used. Cheers, Renaud _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox