Hi All, barebox-2021.10.0 is out. This is a small bugfix release only, no new features are merged. As you might have noticed there is no September release. I was on parental leave for the last three month and so I only occasionally looked at the project. I am back now; patches should be handled in a timely manner again and the next release will contain the patches that have queued up so far. Have fun! Sascha Ahmad Fatoum (11): Documentation: reboot-mode: add note about /env/bmode power: reset: nvmem-reboot-mode: disable device tree fixup startup: don't read glob_t if glob("/env/init/*") fails common: menutree: prevent read of uninitialized memory in error path fs: fat: pbl: support >32M alignment for first partition ARM: at91: at91sam9263ek: add device tree check for board code virtio: implement remove callbacks RISC-V: board-dt-2nd: move low level init into nonnaked function base: driver: fix double removal of child devices blspec: fix use-after-free of firmware search path of: overlay: don't do fixups on empty global.of.overlay.dir Daniel Brát (1): video: Fix broken bcm2835 fb driver Jules Maselbas (2): pbl/Kconfig: fix typo "inflluences" -> "influences" Documentation: Typo fix in command example Sascha Hauer (1): Release v2021.10.0 -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox