Some error messages lack a trailing new line. One dev_dbg uses the i2c
adapter's device_d as domain, before it was allocated. Fix this.
Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
---
drivers/i2c/busses/i2c-designware.c | 8 +++-----
1 file changed, 3 insertions(+), 5 deletions(-)
diff --git a/drivers/i2c/busses/i2c-designware.c b/drivers/i2c/busses/i2c-designware.c
index bb9a0b7c4ad4..8508fac7171f 100644
--- a/drivers/i2c/busses/i2c-designware.c
+++ b/drivers/i2c/busses/i2c-designware.c
@@ -274,7 +274,7 @@ static void i2c_dw_setup_timings(struct dw_i2c_dev *dw)
if (!(dw->sda_hold_time & DW_IC_SDA_HOLD_RX_MASK))
dw->sda_hold_time |= 1 << DW_IC_SDA_HOLD_RX_SHIFT;
- dev_dbg(&dw->adapter.dev, "adjust SDA hold time.\n");
+ dev_dbg(dw->adapter.dev.parent, "adjust SDA hold time.\n");
writel(dw->sda_hold_time, dw->base + DW_IC_SDA_HOLD);
}
}
@@ -547,9 +547,7 @@ static int i2c_dw_probe(struct device_d *pdev)
ic_comp_type_value = readl(dw->base + DW_IC_COMP_TYPE);
if (ic_comp_type_value != DW_IC_COMP_TYPE_VALUE) {
- dev_err(pdev,
- "unknown DesignWare IP block 0x%08x",
- ic_comp_type_value);
+ dev_err(pdev, "unknown DesignWare IP block 0x%08x\n", ic_comp_type_value);
ret = -ENODEV;
goto fail;
}
@@ -574,7 +572,7 @@ static int i2c_dw_probe(struct device_d *pdev)
ic_con = DW_IC_CON_SPEED_FAST;
break;
default:
- dev_warn(pdev, "requested bitrate (%d) is not supported."
+ dev_warn(pdev, "requested bitrate (%d) is not supported.\n"
" Falling back to 100kHz", bitrate);
case 100000: /* FALLTHROUGH */
ic_con = DW_IC_CON_SPEED_STD;
--
2.29.2
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
