There are two different NAND drivers, used for different chips in the i.MX range. It's quite confusing as to which to use. Add some help text to clarify. Signed-off-by: Trent Piepho <tpiepho@xxxxxxxxx> --- Changes from V1: Add GPMI and NFC names, fix typos. drivers/mtd/nand/Kconfig | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-) diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig index 7c9326089..8fb1cedd6 100644 --- a/drivers/mtd/nand/Kconfig +++ b/drivers/mtd/nand/Kconfig @@ -32,14 +32,27 @@ config NAND_ALLOW_ERASE_BAD config NAND_IMX bool - prompt "i.MX NAND driver" + prompt "i.MX21 to 53 NAND driver aka 'mxc', for NFC" depends on ARCH_IMX + help + Support for NAND flash on Freescale/NXP i.MX devices. This is for the + "MXC" series: i.MX21/25/27/31/35/51/53. + + This is not for the "MXS" series i.MX processors (23 & 28), or i.MX6 + and later, which use the GPMI NAND controller from the MXS series. + See the i.MX 'mxs' driver for those chips. config NAND_MXS bool select STMP_DEVICE - prompt "i.MX23/28/6 NAND driver" + prompt "i.MX23/28 & 6+ NAND driver aka 'mxs', for GPMI" depends on MXS_APBH_DMA + help + Support for NAND flash on Freescale/NXP i.MX devices. This is for the + "MXS" series: i.MX23/28 and all i.MX6 and later SoCs. + + This is not for the "MXC" series of i.MX processors in the i.MX21 to + i.MX53 range. See the i.MX "mxc" driver for those chips. config NAND_OMAP_GPMC tristate "NAND Flash Support for GPMC based OMAP platforms" -- 2.26.2 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
