On Tue, Feb 02, 2021 at 07:54:12PM +0100, Michael Grzeschik wrote: > The reference manual says the overcurrent polarity is changed to low > with the bit set. We fix that according to the description. > > Signed-off-by: Michael Grzeschik <m.grzeschik@xxxxxxxxxxxxxx> > --- > drivers/usb/imx/imx-usb-misc.c | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) Applied, thanks Sascha > > diff --git a/drivers/usb/imx/imx-usb-misc.c b/drivers/usb/imx/imx-usb-misc.c > index b663d073aa..660ebecd78 100644 > --- a/drivers/usb/imx/imx-usb-misc.c > +++ b/drivers/usb/imx/imx-usb-misc.c > @@ -353,7 +353,7 @@ static __maybe_unused struct imx_usb_misc_data mx5_data = { > > #define MX6_USB_CTRL(n) ((n) * 4) > #define MX6_USB_CTRL_OVER_CUR_DIS (1 << 7) > -#define MX6_USB_CTRL_OVER_CUR_ACT_HIGH (1 << 8) > +#define MX6_USB_CTRL_OVER_CUR_ACT_LOW (1 << 8) > #define MX6_USB_CTRL_PWR_POLARITY (1 << 9) > > static void mx6_hsic_pullup(unsigned long reg, int on) > @@ -453,9 +453,9 @@ static int usbmisc_imx7d_init(void __iomem *base, int port, > } else { > reg &= ~MX6_USB_CTRL_OVER_CUR_DIS; > if (flags & MXC_EHCI_OC_PIN_ACTIVE_LOW) > - reg &= ~MX6_USB_CTRL_OVER_CUR_ACT_HIGH; > + reg |= MX6_USB_CTRL_OVER_CUR_ACT_LOW; > else > - reg |= MX6_USB_CTRL_OVER_CUR_ACT_HIGH; > + reg &= ~MX6_USB_CTRL_OVER_CUR_ACT_LOW; > } > if (flags & MXC_EHCI_PWR_PIN_ACTIVE_HIGH) > reg |= MX6_USB_CTRL_PWR_POLARITY; > -- > 2.30.0 > > > _______________________________________________ > barebox mailing list > barebox@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/barebox > -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox