Hi, all
I am trying to run barebox on my i.mx6ull board. I inherit from
nxp-imx6ull-evk. When I added nand flash support, system crashed. I
found that the pointer "chip->legacy.set_features" and
"chip->legacy.get_features" in nand_mxs.c was NULL.
I replaced it with nand_set_features() and nand_get_features().
Barebox didn't crash again, but I get the errors:
nand_base: device found, Manufacturer ID: 0x2c, Chip ID: 0xdc
nand_base: Micron MT29F4G08ABAEAWP
nand_base: 512 MiB, SLC, erase size: 256 KiB, page size: 4096,
OOB size: 224
WARNING: at drivers/mtd/nand/nand_base.c:5591/nand_scan_tail()!
WARNING: No oob scheme defined for oobsize 224
mxs_nand 1806000.nand-controller@xxxxxxxxxx: probe failed:
Invalid argument
dts:
&gpmi {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpmi_nand>;
nand-on-flash-bbt;
status = "okay";
};
Did I miss something?
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
