>Hi Alexander, > >On Fri, Oct 16, 2020 at 11:49:16AM +0300, Alexander Shiyan wrote: >> Hello. >> >> Found a regression in arm/lib32/bootm.c after a patch >> "ARM: bootm: make sure we place the kernel in free memory". >> >> The initial memory size for the board is set to 8 MB (before reading the real value from DT), >> so the stack, malloc_space, etc. are placed in the initial 8M space. >> Then get_kernel_addresses() gets the real SDRAM area (for my board it is 64M), >> but decreases this size by the first children size (malloc_space), >> so mem_end is incorrect in this case. >> >> barebox 2020.05.0-00393-gf5e96a296-dirty #80 Thu Oct 15 13:08:54 MSK 2020 >> Board: Mega-Milas Informer EP7312 >> cfi_flash 90000000.nor@0,0.of: found cfi flash at 0x90000000, size 32 MiB >> i2c-gpio i2c0.of: using pins 16 (SDA) and 35 (SCL) >> Hit any to stop autoboot: 1 >> Booting entry 'nor' >> Loading ARM Linux zImage '/dev/nor0.kernel' > >The problem might be that you have the kernel in a raw flash partition. >I think we have problems where we somewhere use the partition size where >we should really use the zImage size. The zImage size must be taken from >the zImage header while we just make a stat() on the file which happens >to be the whole partition for you. > >Could you try and bootm the same zImage from ramfs? I don't understand a little what to do... zImage size is correct (0xc00fca18-0xbfdc6000=0x336a18=3369496) __request_region: 0xbfdc6000:0xc00fca17 outside parent resource 0xc0000000:0xc3ffffff ERROR: bootm/zImage: failed to request memory at 0xbfdc6000 to 0xc00fca18 (3369496). Reverting "ARM: bootm: make sure we place the kernel in free memory" fix this problem. --- _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox