On Wed, Oct 14, 2020 at 08:18:58AM +0200, Rouven Czerwinski wrote: > Add support for the Webasto Common Communication Board Version 2. The > device tree included with barebox can eventually be replaced with the > required barebox changes when the ccbv2 device tree is upstream. > > Signed-off-by: Rouven Czerwinski <r.czerwinski@xxxxxxxxxxxxxx> > --- > v2 → v3: > - Added SPDX license identifier to the flash header > - Combined initcalls and moved to board driver > - Removed unnecessary CONFIG_DEBUG_LL check > - Added board to defconfig and tested defconfig compilation > > v1 → v2: > This should address all comments from the previous patch series, > thanks to Sascha, Ahmad and Roland for the review. > - Barebox should now correctly chainload if early OP-TEE was loaded > - DTS files have been split up > - Uses the iomux file for i.MX6UL to setup the UART instead of magic > values > - Application of the overlay checks the board compatible before > application of the overlay. Applied, thanks Sascha -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox