Did anybody successfully configured Raspberry CM3/CM3+ mini-UART as the Barebox console? I found a thread on this list discussing the issue (https://www.mail-archive.com/barebox@xxxxxxxxxxxxxxxxxxx/msg35235.html), unfortunately without any solution. What I need: * UART0 on pins 32/33 (technology access over rs-485) * UART1 (miniUART) on pins 14/15 (console) My current config.txt boots fine my raspberry kernel (zImage built using builroot): kernel=zImage enable_uart=1 dtoverlay=uart0,txd0_pin=32,rxd0_pin=33,pin_func=7 dtoverlay=uart1,txd1_pin=14,rxd1_pin=15 Now I would like to switch to Barebox as a bootloader. I compiled the barebox image with * CONSOLE_ACTIVATE_NONE = Y * 'stdout-path=&uart1;' in 'arch/arm/dts/bcm2837-rpi-cm3.dts' . and changed my kernel in config.txt kernel=barebox.img I cannot see any output on pins 14/15 e.g. UART1, no barebox console, no kernel console. Any idea what's wrong here? Robert _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
