Convert the global number to the more readable IMX_GPIO_NR() macro, no functional changes. Signed-off-by: Marco Felsch <m.felsch@xxxxxxxxxxxxxx> --- .../boards/freescale-mx6-sabrelite/board.c | 20 +++++++++---------- 1 file changed, 10 insertions(+), 10 deletions(-) diff --git a/arch/arm/boards/freescale-mx6-sabrelite/board.c b/arch/arm/boards/freescale-mx6-sabrelite/board.c index f4f2994a51..020a44297a 100644 --- a/arch/arm/boards/freescale-mx6-sabrelite/board.c +++ b/arch/arm/boards/freescale-mx6-sabrelite/board.c @@ -70,37 +70,37 @@ static int ksz9021rn_phy_fixup(struct phy_device *dev) static struct gpio fec_gpios[] = { { - .gpio = 87, + .gpio = IMX_GPIO_NR(3, 23), .flags = GPIOF_OUT_INIT_LOW, .label = "phy-rst", }, { - .gpio = 190, + .gpio = IMX_GPIO_NR(6, 30), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-addr2", }, { - .gpio = 23, + .gpio = IMX_GPIO_NR(1, 23), .flags = GPIOF_OUT_INIT_LOW, .label = "phy-led-mode", }, { /* MODE strap-in pins: advertise all capabilities */ - .gpio = 185, + .gpio = IMX_GPIO_NR(6, 25), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-adv1", }, { - .gpio = 187, + .gpio = IMX_GPIO_NR(6, 27), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-adv1", }, { - .gpio = 188, + .gpio = IMX_GPIO_NR(6, 28), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-adv1", }, { - .gpio = 189, + .gpio = IMX_GPIO_NR(6, 29), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-adv1", }, { /* Enable 125 MHz clock output */ - .gpio = 184, + .gpio = IMX_GPIO_NR(6, 24), .flags = GPIOF_OUT_INIT_HIGH, .label = "phy-125MHz", }, @@ -139,9 +139,9 @@ fs_initcall(sabrelite_ksz9021rn_setup); static void sabrelite_ehci_init(void) { /* hub reset */ - gpio_direction_output(204, 0); + gpio_direction_output(IMX_GPIO_NR(7, 12), 0); udelay(2000); - gpio_set_value(204, 1); + gpio_set_value(IMX_GPIO_NR(7, 12), 1); } static int sabrelite_devices_init(void) -- 2.20.1 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox