On Thu, Aug 20, 2020 at 09:34:42AM +0200, Oleksij Rempel wrote: > changes v5: > - board: apply requested changes > - add PHY and rs458 devicetree fixes for lanmcu and plym2m > > changes v4: > - follow suggestion provided by Ahmad and open-code the root node > registration and call it machine.of > - board: rename crc and cs > - board: ignore most of init related errors. Even if one part will fail, > we should be able to get as mach as possible. > > changes v3: > - remove barebox-serial driver and use read the rfid directy from board > code (as was done in initial implementation) > - use initcall instead of registering driver in the board code > - add delayed USB scan > - add rampoops node > - add partition tables > > changes v2: > - add power init support for KvG boards > - spell fixes > - do not print error on probe exit > - add of_console_get_by_alias() helper > - free requested gpio array > - exit fec init only in case of PROBE_DEFERED > > This patch series is a preparation and actual Protonic board code. > Following changes was made in the main code: > - register DT root node as device to make it possible to loade board > code as usual driver > - provide helpers to read ethernet mac from nvmem cell register in a > devicetree. > - provide barebox-serial driver which should be a nvmem cell consumer > and > serial-number DT property provider. > - provide gpio helper to read gpio based board revision. > > Oleksij Rempel (12): > of: base: register DT root as device > gpiolib: add gpio_array_to_id helper to get ID out of GPIO array > common: console_common: add of_console_get_by_alias() helper > of: of_device_get_match_compatible() helper > ARM: protonic-imx6: port Protonic specific board code > ARM: dts: unify barebox and barebox,env partitions for all Protonic > boards > ARM: dts: imx6q-prti6q: add pstore/ramoops node > ARM: dts: protonic: lanmcu: add eMMC partition table > ARM: dts: protonic: add fixed clock for the FEC node > ARM: dts: protonic: lanmcu: use UART_CTS instead of GPIO based CTS > ARM: dts: protonic: properly define PHY nodes on lanmcu and plym2m > boards > ARM: dts: protonic: lanmcu: add uart-has-rtscts to enable rs485 > functionality Applied, thanks Sascha -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
