Sync it with Protonic PLYBAS board to have same, reproducible behavior on all boards. Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx> --- arch/arm/dts/imx6dl-lanmcu.dts | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) diff --git a/arch/arm/dts/imx6dl-lanmcu.dts b/arch/arm/dts/imx6dl-lanmcu.dts index 65f6cbf395..42f8c91ece 100644 --- a/arch/arm/dts/imx6dl-lanmcu.dts +++ b/arch/arm/dts/imx6dl-lanmcu.dts @@ -201,7 +201,7 @@ fsl,pins = < MX6QDL_PAD_EIM_D26__UART2_RX_DATA 0x1b0b1 MX6QDL_PAD_EIM_D27__UART2_TX_DATA 0x1b0b1 - MX6QDL_PAD_EIM_D28__GPIO3_IO28 0x130b1 + MX6QDL_PAD_EIM_D28__UART2_CTS_B 0x130b1 >; }; @@ -209,7 +209,7 @@ fsl,pins = < MX6QDL_PAD_EIM_D24__UART3_TX_DATA 0x1b0b1 MX6QDL_PAD_EIM_D25__UART3_RX_DATA 0x1b0b1 - MX6QDL_PAD_EIM_D30__GPIO3_IO30 0x130b1 + MX6QDL_PAD_EIM_D30__UART3_CTS_B 0x130b1 >; }; @@ -320,7 +320,6 @@ pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart2>; linux,rs485-enabled-at-boot-time; - rts-gpios = <&gpio3 28 GPIO_ACTIVE_HIGH>; status = "okay"; }; @@ -328,7 +327,6 @@ pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart3>; linux,rs485-enabled-at-boot-time; - rts-gpios = <&gpio3 30 GPIO_ACTIVE_HIGH>; status = "okay"; }; -- 2.28.0 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
