[PATCH v2] serial: imx: set CTS if DT property "linux, rs485-enabled-at-boot-time" is present

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



If we have a "linux,rs485-enabled-at-boot-time" DT property, we should
set CTS flag as soon as possible to the active state. This will set an
RS485 transmitter to receive-enable mode. Otherwise the RS485 bus will
be blocked for entire system boot time and other bus participants will
not be able to communicate.

Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
 drivers/serial/serial_imx.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/serial/serial_imx.c b/drivers/serial/serial_imx.c
index c0265fc2d7..056fa14c2a 100644
--- a/drivers/serial/serial_imx.c
+++ b/drivers/serial/serial_imx.c
@@ -60,6 +60,7 @@ struct imx_serial_priv {
 	void __iomem *regs;
 	struct clk *clk;
 	struct imx_serial_devtype_data *devtype;
+	bool rs485_mode;
 };
 
 static int imx_serial_reffreq(struct imx_serial_priv *priv)
@@ -107,6 +108,9 @@ static int imx_serial_init_port(struct console_device *cdev)
 
 	/* Enable FIFOs */
 	val = readl(regs + UCR2);
+	/* set CTS to not block RS485 bus */
+	if (priv->rs485_mode)
+		val |= UCR2_CTS;
 	val |= UCR2_SRST | UCR2_RXEN | UCR2_TXEN;
 	writel(val, regs + UCR2);
 
@@ -252,6 +256,10 @@ static int imx_serial_probe(struct device_d *dev)
 	if (of_property_read_bool(dev->device_node, "fsl,dte-mode"))
 		priv->dte_mode = 1;
 
+	if (of_property_read_bool(dev->device_node, "linux,rs485-enabled-at-boot-time") &&
+	    !of_property_read_bool(dev->device_node, "rs485-rts-active-low"))
+		priv->rs485_mode = 1;
+
 	imx_serial_init_port(cdev);
 
 	/* Enable UART */
-- 
2.28.0


_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux