For eMMC, the boot partitions for FSBL instead of having two partitions
in the user area, like with SD-Card. Document this.
Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
---
Documentation/boards/stm32mp.rst | 19 +++++++++++++++++--
1 file changed, 17 insertions(+), 2 deletions(-)
diff --git a/Documentation/boards/stm32mp.rst b/Documentation/boards/stm32mp.rst
index 6d97b0d6d4a2..1253da52f15b 100644
--- a/Documentation/boards/stm32mp.rst
+++ b/Documentation/boards/stm32mp.rst
@@ -35,7 +35,7 @@ The resulting images will be placed under ``images/``:
Flashing barebox
----------------
-An appropriate image for the boot media can be generated with following
+An appropriate image for a SD-Card can be generated with following
``genimage(1)`` config::
image @STM32MP_BOARD@.img {
@@ -61,7 +61,22 @@ An appropriate image for the boot media can be generated with following
}
}
-Image can then be flashed on e.g. a SD-Card.
+For eMMC, the boot partitions are used as the FSBL partitions and so the user
+partitions may look like this:
+
+ image @STM32MP_BOARD@.img {
+ partition ssbl {
+ image = "barebox-@STM32MP_BOARD@.img"
+ size = 1M
+ }
+ partition barebox-environment {
+ image = "/dev/null"
+ size = 1M
+ }
+ }
+
+The fsbl1 and fsbl2 can be flashed by writing to ``/dev/mmcX.boot0`` from inside
+barebox or from a booted operating system.
Boot source selection
---------------------
--
2.25.0
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
