mode and alt are printed with the dev_dbg before they are initialized. Remedy this by moving the dev_dbg after them. Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx> --- drivers/pinctrl/pinctrl-stm32.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/pinctrl/pinctrl-stm32.c b/drivers/pinctrl/pinctrl-stm32.c index 7f04cea50b75..ab121998a37f 100644 --- a/drivers/pinctrl/pinctrl-stm32.c +++ b/drivers/pinctrl/pinctrl-stm32.c @@ -157,13 +157,13 @@ static int stm32_pinctrl_set_state(struct pinctrl_device *pdev, struct device_no if (offset < 0) return -ENODEV; + mode = stm32_gpio_get_mode(func); + alt = stm32_gpio_get_alt(func); + dev_dbg(pdev->dev, "configuring port %s pin %u with:\n\t" "fn %u, mode %u, alt %u\n", bank->name, offset, func, mode, alt); - mode = stm32_gpio_get_mode(func); - alt = stm32_gpio_get_alt(func); - clk_enable(bank->clk); __stm32_pmx_set_mode(bank->base, offset, mode, alt); -- 2.23.0 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
