On Tue, Aug 20, 2019 at 10:17:36PM +0000, Cory Tusar wrote: > When attempting to use the existing configuration file to bootstrap > an SCU4 AIB board, openocd would consistently fail on the 'halt' command > with a "Target not examined yet" error. Dumping target information > showed that vf610.cpu1 was the active target, rather that vf610.cpu0. > > Adding a command prior to the halt to explicitly set the target core > resulted in proper operation. > > Tested with openocd-0.10.0+dev-00924-g16496488 on a Zodiac SCU4 AIB. > > Signed-off-by: Cory Tusar <cory.tusar@xxxxxxxx> > --- > Documentation/boards/imx/zii-vf610-dev/openocd.cfg | 1 + > 1 file changed, 1 insertion(+) Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox