Re: eMMC probe in imx8mm

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Reyhaneh,

On Fri, Jul 05, 2019 at 02:04:08PM +0000, Yazdani, Reyhaneh wrote:
> Hello everyone,
> 
> I have brought up Barebox on imx8mm-evk board. Barebox is programmed on SD-card.
> In the Barebox console, when I probe eMMC, I will receive I/O error.
> 
> Therefore, similar to the imx8mq device tree, I added clk node to assign
> clock-parent and clock-rates of the assigned clock of the eMMC (usdhc3):
> 
> &clk {
>         assigned-clocks =  <&clk IMX8MM_CLK_USDHC3_ROOT>;
>         assigned-clock-parents =  <&clk IMX8MM_SYS_PLL1_400M>;
>         assigned-clock-rates = <200000000>;
> };
> 
> Now, eMMC probe works and eMMC is detected. But when I want to boot from eMMC,
> 
> Loading ARM aarch64 Linux image '/mnt/mmc2/Image' takes about 13-14 seconds!!

How big is this image?

Is only the eMMC card so slow or the SD card aswell?

Does clk_dump give you any clue which clock rate the usdhc controller
actually has (and is it the same as the other controller with the SD
card)?

Just some questions, I am not very familiar with the i.MX8 clock tree.

Sascha


-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |

_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux