Hello everyone, On the process of bring-up imx8mm board, I am at the point that load bl31 and jump to ATF.Upon exit from ATF's initialization routine, the execution level should be EL2. My question is about imx8mq_atf_load_bl31 function. After copy BL31 into OCRAM address, the function sets up the sp_el2 to "MX8MQ_ATF_BL33_BASE_ADDR - 16". Can anyone explain me why this address? Because I am using the same address for imx8mm and it seems Barebox does not return to this point. Best, Reyhaneh -- Reyhaneh Yazdani Data Modul AG TEL: +49-89-56017-154 Embedded development FAX: +49-89-56017-119 Linux - Development RG: HR-Muenchen B-85591 Landsberger Str. 322 D-80687 Muenchen - http://www.data-modul.com Vertrauliche E-Mail von / Confidential e-mail from: DATA MODUL AG Vorstand / CEO: Dr. Florian Pesahl Vorsitzende des Aufsichtsrates / Chairwoman of the Supervisory Board: Kristin D. Russell Sitz der Gesellschaft / Registered Office: München Registergericht / Registration Court: München Handelsregister B 85 591 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
