On Mon, Jun 17, 2019 at 05:07:39PM +0200, Ahmad Fatoum wrote: > Feedback welcome. > > I still have a patch that ports designware_qos from U-Boot to barebox > sitting on my branch. It works fine, but it needs refactoring, so it > can reuse existing functionality in the generic designware MAC driver > that's already in barebox. That will take a while, but if there's interest > in it, I can push the current state somwhere till then. > > Cheers, > Ahmad Fatoum (12): > ARM: dts: stm32mp157a-dk1.dts: include upstream dts before barebox' > ARM: dts: stm32mp: factor out common DK nodes into dtsi > gpiolib: add gpio_get_chip helper > driver: add stubs for hardware spinlocks > pinctrl: add driver for STM32 GPIO and pin multiplexer > ARM: dts: stm32mp157a-dk1: enable heartbeat and error LEDs > ARM: stm32mp: turn on GPIO related options > ARM: stm32mp157c-dk2: add board-specific sysconf fixups > ARM: psci: fix erroneous call of ->system_reset on system_off > ARM: sm: move get_gicd_base_address to header for reuse > ARM: stm32mp: implement PSCI support > ARM: stm32mp157c-dk2: boot kernel in nonsecure mode Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
