On Wed, Apr 03, 2019 at 05:31:09PM +0200, Mihaita Ivascu wrote: > Hello, > > I have the following situation: > > I use imx6ul platforms. > kernel 4.9.11 from NXP > barebox 2018.04.10 > > I create and update an FIT image(*.itb) using > ubiformat/ubiattach/ubimkvol/ubiupdatevol commands > > I also do this operation from Linux once the kernel was booted. > Everything worked for a while but at some point the FITIMAGE size > increased over 50 MB and I adapted the nand table in device tree > sources. > > Now the image update from barebox is still working, I update, the > kernel loads and then at the next reboot the target boots correctly. > But if do the the FIt image update from linux, the update is > finished without warnings but at the next reboot, the barebox will > complained as listed in the attachment and the target won't boot from > nand anymore. Then i have to do the update again but only from > barebox. > > nand partition table is the same in kernel and barebox dts. > But for images larger than 50 MB somehow if I update from linux, the > barebox will complain about ECC code 74. > I have enabled the other ECC options(software with/without BCH, > hardware) both in barebox and linux but no change. > I don't know if/how should I play with the PEB settings. > > Does anybody know how could I get around this issue or how to > continue with my investigation? > > Thanks in advance, > Mihaita Ivascu > barebox 2018.04.0 #2 Wed Apr 3 07:55:40 PDT 2019 > > > Board: Phytec phyCORE-i.MX6 Ultra Lite SOM > detected i.MX6 UltraLite revision 1.2 > mdio_bus: miibus0: probed > eth0: got preset MAC address: 50:2d:f4:14:96:09 > nand: ONFI flash detected > nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xdc (Micron MT29F4G08ABADAH4), 512MiB, page size: 2048, OOB size: 64 > Bad block table found at page 262080, version 0x01 > Bad block table found at page 262016, version 0x01 > nand_bbt: ECC error in BBT at 0x00001ffe0005 > nand_bbt: ECC error in BBT at 0x00001ffc0005 Things go wrong here already. Could it be that you use a flash based bbt in barebox but not in Linux? Generally have you made sure that you can write a page in barebox and read it in Linux, then afterwards the other way round? I have no idea what the Freescale Kernel does. It might have some options to use other ECC modes or something like that. Looking at the device tree nodes might give a clue. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
