The newly added device tree based first stage fails to load the second
stage from MMC, which might be in relation to a preceding atmel_mci
"command/data timeout" message.
Due to this and because it's not clear yet how viable it's to use the device
tree for the size-constrained first stage anyway, make CONFIG_OFDEVICE
configurable and provide a legacy board code based fallback whenever it's
unselected. The resulting image is 48K big with PBL_CONSOLE compared to
72K for the device tree based version without PBL_CONSOLE.
If barebox can be shrunk further and the device tree support in the
first stage was fixed, this commit could be reverted for full device
tree goodness.
The board code is a stripped down version of the sama5d3_xplained board's.
Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
---
.../arm/boards/microchip-ksz9477-evb/Makefile | 3 +
arch/arm/boards/microchip-ksz9477-evb/board.c | 127 ++++++++++++++++++
.../boards/microchip-ksz9477-evb/lowlevel.c | 3 +-
...rochip_ksz9477_evb_bootstrap_mmc_defconfig | 24 ++++
arch/arm/mach-at91/Kconfig | 14 +-
5 files changed, 167 insertions(+), 4 deletions(-)
create mode 100644 arch/arm/boards/microchip-ksz9477-evb/board.c
create mode 100644 arch/arm/configs/microchip_ksz9477_evb_bootstrap_mmc_defconfig
diff --git a/arch/arm/boards/microchip-ksz9477-evb/Makefile b/arch/arm/boards/microchip-ksz9477-evb/Makefile
index b08c4a93ca27..8d0379a3f59f 100644
--- a/arch/arm/boards/microchip-ksz9477-evb/Makefile
+++ b/arch/arm/boards/microchip-ksz9477-evb/Makefile
@@ -1 +1,4 @@
lwl-y += lowlevel.o
+ifeq ($(CONFIG_MACH_MICROCHIP_KSZ9477_EVB_DT),)
+obj-y += board.o
+endif
diff --git a/arch/arm/boards/microchip-ksz9477-evb/board.c b/arch/arm/boards/microchip-ksz9477-evb/board.c
new file mode 100644
index 000000000000..455b9aca3ab0
--- /dev/null
+++ b/arch/arm/boards/microchip-ksz9477-evb/board.c
@@ -0,0 +1,127 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/*
+ * Copyright (C) 2014 Bo Shen <voice.shen@xxxxxxxxx>
+ */
+
+#include <init.h>
+#include <mach/board.h>
+#include <mach/iomux.h>
+
+#if defined(CONFIG_NAND_ATMEL)
+static struct atmel_nand_data nand_pdata = {
+ .ale = 21,
+ .cle = 22,
+ .det_pin = -EINVAL,
+ .rdy_pin = -EINVAL,
+ .enable_pin = -EINVAL,
+ .ecc_mode = NAND_ECC_HW,
+ .has_pmecc = 1,
+ .pmecc_sector_size = 512,
+ .pmecc_corr_cap = 4,
+ .bus_width_16 = 1,
+ .on_flash_bbt = 1,
+};
+
+static struct sam9_smc_config sama5d3_xplained_nand_smc_config = {
+ .ncs_read_setup = 1,
+ .nrd_setup = 2,
+ .ncs_write_setup = 1,
+ .nwe_setup = 2,
+
+ .ncs_read_pulse = 5,
+ .nrd_pulse = 3,
+ .ncs_write_pulse = 5,
+ .nwe_pulse = 3,
+
+ .read_cycle = 8,
+ .write_cycle = 8,
+
+ .mode = AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE,
+ .tdf_cycles = 3,
+
+ .tclr = 3,
+ .tadl = 10,
+ .tar = 3,
+ .ocms = 0,
+ .trr = 4,
+ .twb = 5,
+ .rbnsel = 3,
+ .nfsel = 1
+};
+
+static void ek_add_device_nand(void)
+{
+ struct clk *clk = clk_get(NULL, "smc_clk");
+
+ clk_enable(clk);
+
+ /* setup bus-width (8 or 16) */
+ if (nand_pdata.bus_width_16)
+ sama5d3_xplained_nand_smc_config.mode |= AT91_SMC_DBW_16;
+ else
+ sama5d3_xplained_nand_smc_config.mode |= AT91_SMC_DBW_8;
+
+ /* configure chip-select 3 (NAND) */
+ sama5_smc_configure(0, 3, &sama5d3_xplained_nand_smc_config);
+
+ at91_add_device_nand(&nand_pdata);
+}
+#else
+static void ek_add_device_nand(void) {}
+#endif
+
+#if defined(CONFIG_MCI_ATMEL)
+/*
+ * MCI (SD/MMC)
+ */
+static struct atmel_mci_platform_data mci0_data = {
+ .bus_width = 8,
+ .detect_pin = AT91_PIN_PE0,
+ .wp_pin = -EINVAL,
+};
+
+static void ek_add_device_mci(void)
+{
+ /* MMC0 */
+ at91_add_device_mci(0, &mci0_data);
+}
+#else
+static void ek_add_device_mci(void) {}
+#endif
+
+static int sama5d3_xplained_mem_init(void)
+{
+ at91_add_device_sdram(0);
+
+ return 0;
+}
+mem_initcall(sama5d3_xplained_mem_init);
+
+static const struct devfs_partition sama5d3_xplained_nand0_partitions[] = {
+ {
+ .offset = 0x00000,
+ .size = SZ_256K,
+ .flags = DEVFS_PARTITION_FIXED,
+ .name = "at91bootstrap_raw",
+ .bbname = "at91bootstrap",
+ }, {
+ .offset = DEVFS_PARTITION_APPEND, /* 256 KiB */
+ .size = SZ_1M,
+ .flags = DEVFS_PARTITION_FIXED,
+ .name = "self_raw",
+ .bbname = "self0",
+ }, {
+ /* sentinel */
+ }
+};
+
+static int sama5d3_xplained_devices_init(void)
+{
+ ek_add_device_nand();
+ ek_add_device_mci();
+
+ devfs_create_partitions("nand0", sama5d3_xplained_nand0_partitions);
+
+ return 0;
+}
+device_initcall(sama5d3_xplained_devices_init);
diff --git a/arch/arm/boards/microchip-ksz9477-evb/lowlevel.c b/arch/arm/boards/microchip-ksz9477-evb/lowlevel.c
index cf44021bdfb7..bf9a4aed6183 100644
--- a/arch/arm/boards/microchip-ksz9477-evb/lowlevel.c
+++ b/arch/arm/boards/microchip-ksz9477-evb/lowlevel.c
@@ -195,7 +195,8 @@ static noinline void board_init(void)
sama5d3_ddramc_init();
- fdt = __dtb_z_at91_microchip_ksz9477_evb_boot_bin_start + get_runtime_offset();
+ if (IS_ENABLED(CONFIG_MACH_MICROCHIP_KSZ9477_EVB_DT))
+ fdt = __dtb_z_at91_microchip_ksz9477_evb_boot_bin_start + get_runtime_offset();
barebox_arm_entry(SAMA5_DDRCS, SZ_256M, fdt);
}
diff --git a/arch/arm/configs/microchip_ksz9477_evb_bootstrap_mmc_defconfig b/arch/arm/configs/microchip_ksz9477_evb_bootstrap_mmc_defconfig
new file mode 100644
index 000000000000..8af85bc10613
--- /dev/null
+++ b/arch/arm/configs/microchip_ksz9477_evb_bootstrap_mmc_defconfig
@@ -0,0 +1,24 @@
+CONFIG_ARCH_SAMA5D3=y
+CONFIG_AT91_MULTI_BOARDS=y
+CONFIG_MACH_MICROCHIP_KSZ9477_EVB=y
+CONFIG_AT91_BOOTSTRAP=y
+CONFIG_MALLOC_TLSF=y
+CONFIG_RELOCATABLE=y
+CONFIG_PROMPT="BOOT.BIN:"
+CONFIG_SHELL_NONE=y
+# CONFIG_TIMESTAMP is not set
+CONFIG_CONSOLE_SIMPLE=y
+CONFIG_PBL_CONSOLE=y
+CONFIG_DEFAULT_LOGLEVEL=6
+CONFIG_DEBUG_LL=y
+# CONFIG_SPI is not set
+CONFIG_MCI=y
+CONFIG_MCI_STARTUP=y
+# CONFIG_MCI_WRITE is not set
+CONFIG_MCI_ATMEL=y
+CONFIG_MFD_SYSCON=y
+# CONFIG_FS_RAMFS is not set
+# CONFIG_FS_DEVFS is not set
+CONFIG_FS_FAT=y
+CONFIG_BOOTSTRAP_DEVFS=y
+CONFIG_BOOTSTRAP_DISK=y
diff --git a/arch/arm/mach-at91/Kconfig b/arch/arm/mach-at91/Kconfig
index e72e37c2bf9e..827b05a23496 100644
--- a/arch/arm/mach-at91/Kconfig
+++ b/arch/arm/mach-at91/Kconfig
@@ -18,6 +18,15 @@ config MACH_AT91SAM9263EK_DT
Enabled for at91sam9263ek - evaluation kit.
But only if we need the device tree (bootstrap do not use DT)
+config MACH_MICROCHIP_KSZ9477_EVB_DT
+ def_bool y
+ depends on MACH_MICROCHIP_KSZ9477_EVB && OFDEVICE
+ select ARM_USE_COMPRESSED_DTB
+ help
+ Enabled for Microchip KSZ9477 - evaluation kit.
+ But only if we need the device tree (bootstrap doesn't yet work with
+ DT)
+
config HAVE_AT91_SMD
bool
@@ -546,9 +555,8 @@ config MACH_AT91SAM9X5EK
config MACH_MICROCHIP_KSZ9477_EVB
bool "Microchip EVB-KSZ9477 Evaluation Kit"
depends on ARCH_SAMA5D3
- select OFDEVICE
- select COMMON_CLK_OF_PROVIDER
- select ARM_USE_COMPRESSED_DTB
+ select OFDEVICE if !AT91_LOAD_BAREBOX_SRAM
+ select COMMON_CLK_OF_PROVIDER if OFDEVICE
select HAVE_AT91_BOOTSTRAP
help
Select this if you are using Microchip's EVB-KSZ9477 Evaluation Kit.
--
2.20.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
