On Mon, Feb 18, 2019 at 12:32:12PM +0100, Tomaz Solc wrote: > Changes from the first patch series: > > - Base Compute Module 3 device tree off upstream device tree for CM3 + IO3 > dev board, instead of R. Pi 3B. > - Keep Makefile.bcm283x without a newline at the end of file. > - Make mci init before pinctrl by moving mci-bcm2835 to device_initcall() > instead of changing link order. > - Add CONFIG_PINCTRL to rpi_defconfig. > > Best regards > Tomaz > > Tomaz Solc (8): > ARM: rpi: switch emmc from sdhost to sdhci > Kconfig: add pin controllers submenu. > pinctrl: bcm2835: move existing code from gpio. > pinctrl: bcm2835: register the pin controller. > mci: bcm2835: use device_initcall(), not coredev. > mci: bcm2835: parse other device tree properties. > ARM: rpi: Add device tree for Compute Module 3. > ARM: rpi: add CONFIG_PINCTRL to rpi_defconfig. Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
