E1000_ich8lan, e1000_82573, e1000_82574 and e1000_igb
devices (hw->mac_type) do not use data read from
EEPROM_INIT_CONTROL2_REG in e1000_setup_link(), so there's no reason
for it to bail out when EEPROM read fails. An examlpe use-case would
be a i210 adapter initialized from iNVM with no valid EEPROM attached.
Change the code to only call e1000_read_eeprom() for devices that do
need it.
Signed-off-by: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>
---
drivers/net/e1000/main.c | 31 ++++++++++++++++---------------
1 file changed, 16 insertions(+), 15 deletions(-)
diff --git a/drivers/net/e1000/main.c b/drivers/net/e1000/main.c
index 87ee46094..0ef8fd623 100644
--- a/drivers/net/e1000/main.c
+++ b/drivers/net/e1000/main.c
@@ -832,21 +832,6 @@ static int e1000_setup_link(struct e1000_hw *hw)
if (e1000_check_phy_reset_block(hw))
return E1000_SUCCESS;
- /* Read and store word 0x0F of the EEPROM. This word contains bits
- * that determine the hardware's default PAUSE (flow control) mode,
- * a bit that determines whether the HW defaults to enabling or
- * disabling auto-negotiation, and the direction of the
- * SW defined pins. If there is no SW over-ride of the flow
- * control setting, then the variable hw->fc will
- * be initialized based on a value in the EEPROM.
- */
- ret_val = e1000_read_eeprom(hw, EEPROM_INIT_CONTROL2_REG, 1,
- &eeprom_data);
- if (ret_val < 0) {
- dev_err(hw->dev, "EEPROM Read Error\n");
- return ret_val;
- }
-
switch (hw->mac_type) {
case e1000_ich8lan:
case e1000_82573:
@@ -855,6 +840,22 @@ static int e1000_setup_link(struct e1000_hw *hw)
hw->fc = e1000_fc_full;
break;
default:
+ /* Read and store word 0x0F of the EEPROM. This word
+ * contains bits that determine the hardware's default
+ * PAUSE (flow control) mode, a bit that determines
+ * whether the HW defaults to enabling or disabling
+ * auto-negotiation, and the direction of the SW
+ * defined pins. If there is no SW over-ride of the
+ * flow control setting, then the variable hw->fc will
+ * be initialized based on a value in the EEPROM.
+ */
+ ret_val = e1000_read_eeprom(hw, EEPROM_INIT_CONTROL2_REG, 1,
+ &eeprom_data);
+ if (ret_val < 0) {
+ dev_err(hw->dev, "EEPROM Read Error\n");
+ return ret_val;
+ }
+
if ((eeprom_data & EEPROM_WORD0F_PAUSE_MASK) == 0)
hw->fc = e1000_fc_none;
else if ((eeprom_data & EEPROM_WORD0F_PAUSE_MASK) == EEPROM_WORD0F_ASM_DIR)
--
2.19.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
