[PATCH 1/4] ARM: rdu2: config PMIC SW1AB and SW1C rails to 1.375

[Lucas Stach <l.stach@xxxxxxxxxxxxxx>]

This is the default out-of-reset voltage, but if only the i.MX6 SoC
got reset, the PMIC might still be stuck at the lower volatge for the
slow operating point.

Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
---
 arch/arm/boards/zii-imx6q-rdu2/board.c | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boards/zii-imx6q-rdu2/board.c b/arch/arm/boards/zii-imx6q-rdu2/board.c
index c99f993f02b8..49cc234c020b 100644
--- a/arch/arm/boards/zii-imx6q-rdu2/board.c
+++ b/arch/arm/boards/zii-imx6q-rdu2/board.c
@@ -16,6 +16,7 @@
 #include <common.h>
 #include <envfs.h>
 #include <gpio.h>
+#include <i2c/i2c.h>
 #include <init.h>
 #include <mach/bbu.h>
 #include <mach/imx6.h>
@@ -137,10 +138,27 @@ late_initcall(rdu2_enable_front_panel_usb);
 
 static int rdu2_devices_init(void)
 {
+	struct i2c_client client;
+
 	if (!of_machine_is_compatible("zii,imx6q-zii-rdu2") &&
 	    !of_machine_is_compatible("zii,imx6qp-zii-rdu2"))
 		return 0;
 
+	client.adapter = i2c_get_adapter(1);
+	if (client.adapter) {
+		u8 reg;
+
+		/*
+		 * Reset PMIC SW1AB and SW1C rails to 1.375V. If an event
+		 * caused only the i.MX6 SoC reset, the PMIC might still be
+		 * stuck on the low voltage for the slow operating point.
+		 */
+		client.addr = 0x08; /* PMIC i2c address */
+		reg = 0x2b; /* 1.375V, valid for both rails */
+		i2c_write_reg(&client, 0x20, &reg, 1);
+		i2c_write_reg(&client, 0x2e, &reg, 1);
+	}
+
 	barebox_set_hostname("rdu2");
 
 	imx6_bbu_internal_spi_i2c_register_handler("SPI", "/dev/m25p0.barebox",
-- 
2.19.1


_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox