Everyone:
This series is the result simplification, bugfixing and adding
features to some of the code in BBU subsytem:
- Patch 2 "filetype: Add code to detect i.MX image v1" is not really
used anywhere in the series and is provided for the sake of
completness. It should probably dropeed but I thought I'd include
it just in case
- Patches 1, 3 - 12 are a number of code simplifications intended to
minimize amount of duplicated code as well as generic improvements
(IMHO)
- Patches 13 - 17 are i.MX8MQ and VF610 related changes
- Patches 18 - 22 are a result of discovering that a number of error
cases were silently ignored and not reported as update
failures. Patch 20 is technically not related to BBU at all, but
since I discovered the problem while working on this series, I
kept it as a part of this series
This patchset was tested of following platforms:
- i.MX51 ZII RDU1 (SPI-NOR and eMMC)
- i.MX6Q ZII RDU2 (SPI-NOR and eMMC)
- VF610 ZII Vybrid Dev Board Rev C. (SPI-NOR)
- i.MX8MQ NXP EVK (eMMC)
- i.MX8MQ ZII RDU3 (not supported by upstream Barebox)
Feedback is wellcome!
Thanks,
Andrey Smirnov
Andrey Smirnov (22):
ARM: i.MX: bbu: Remove unused define
filetype: Add code to detect i.MX image v1
filetype: Add code to detect i.MX image v2
ARM: i.MX: bbu: Move inner-image type check
ARM: i.MX: bbu: Drop IMX_INTERNAL_FLAG_NAND
ARM: i.MX: bbu: Consolidate vairous update helpers
ARM: i.MX: bbu: Simplify imx53_bbu_internal_nand_register_handler()
ARM: i.MX: bbu: Constify all 'devicefile' arguments
ARM: i.MX: bbu: Detect which platforms need v2 i.MX header
ARM: i.MX: bbu: Alias imx5*_bbu_internal_mmc_register_handler()
ARM: i.MX: bbu: Alias imx5*_bbu_internal_spi_i2c_register_handler()
ARM: i.MX: bbu: Move protect code into a separate routine
ARM: i.MX: bbu: Adjust FLASH_HEADER_OFFSET_MMC for i.MX8MQ
ARM: i.MX: bbu: Add support for SPI/I2C on VFxxx
ARM: i.MX: zii-vf610-dev-rev-b/c: Add support for BBU on SPI-NOR
ARM: i.MX: bbu: Add support for MMC on i.MX8MQ
ARM: nxp-imx8mq-evk: Add eMMC BBU configuration
ARM: i.MX: bbu: Adjust error code check for pwrite()
bbu: Remove logical negation in barebox_update_handler_exists()
block: Do not ignore error in blk->ops->write()
bbu: Report update failures explicitly
bbu: command: Make sure specified update handler exists
arch/arm/boards/nxp-imx8mq-evk/board.c | 3 +
arch/arm/boards/zii-vf610-dev/board.c | 19 ++
arch/arm/dts/vf610-zii-dev-rev-b.dts | 11 +
arch/arm/mach-imx/imx-bbu-internal.c | 339 ++++++++++++++-----------
arch/arm/mach-imx/include/mach/bbu.h | 60 +++--
commands/barebox-update.c | 15 +-
common/bbu.c | 14 +-
common/block.c | 17 +-
common/filetype.c | 11 +
include/filetype.h | 2 +
10 files changed, 307 insertions(+), 184 deletions(-)
--
2.17.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
