On Mon, Jan 15, 2018 at 10:39:51PM +0100, Sam Ravnborg wrote: > This is version 3 of a patchset to enable > device tree support for AT91SAM9263EK. > > The patchset is made on top of previous > patches posted that move reset code to > the board files for at91 boards. > (Which are already part of -next) > > On the quest towards getting so far several drivers was > converted to support DT. > These patches went in around august. > > There was also issues with mach-at91 calling code > in the board directory (dependency in the > wrong direction). > This was fixed in "at91: move reset .." which is > pending (already posted). > > I have failed to get the bootstrap mode to work. > It stops somewhere - and I have not invested enough > time to figure out where and why things goes wrong. > bootstrap mode was also broken before these patches. > No JTAG debugger available to help me. > And then I have at91bootstrap that works so motivation > was not too high. > > I do not think the NAND support works either. > The device tree introduces some nand-controller > stuff that is not supported by barebox (at least I assume so). > And this part I did not look further into. > > Next step is to get a proprietary board up and > running (which uses NOR flash). > But I wanted this patchset out in the open first. > > Thanks for feedback so far - especially from Andrey. > > Sam > > v2 => v3 > - Squashed commit introducing support for multi image > with the commit to add DT support > - Fixed init of smc Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
