[PATCH 3/5] at91sam9263ek: fix SD card in DT

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The DT file from the linux kernel uses mmc0 for SD card,
but the evaluation board uses mmc1.
Fix DT file so it has same behaviour like the non-DT
version where mmc1 is used.

Signed-off-by: Sam Ravnborg <sam@xxxxxxxxxxxx>
---
 arch/arm/dts/at91sam9263ek.dts | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/arch/arm/dts/at91sam9263ek.dts b/arch/arm/dts/at91sam9263ek.dts
index 224748ecc..7d0ae0447 100644
--- a/arch/arm/dts/at91sam9263ek.dts
+++ b/arch/arm/dts/at91sam9263ek.dts
@@ -55,12 +55,13 @@
 				status = "okay";
 			};
 
-			mmc0: mmc@fff80000 {
+			mmc1: mmc@fff84000 {
 				pinctrl-0 = <
-					&pinctrl_board_mmc0
-					&pinctrl_mmc0_clk
-					&pinctrl_mmc0_slot0_cmd_dat0
-					&pinctrl_mmc0_slot0_dat1_3>;
+					&pinctrl_board_mmc1
+					&pinctrl_mmc1_clk
+					&pinctrl_mmc1_slot0_cmd_dat0
+					&pinctrl_mmc1_slot0_dat1_3>;
+				cd-gpios = <&pioE 18 GPIO_ACTIVE_HIGH>;
 				status = "okay";
 				slot@0 {
 					reg = <0>;
@@ -71,8 +72,8 @@
 			};
 
 			pinctrl@fffff200 {
-				mmc0 {
-					pinctrl_board_mmc0: mmc0-board {
+				mmc1 {
+					pinctrl_board_mmc1: mmc1-board {
 						atmel,pins =
 							<AT91_PIOE 18 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP_DEGLITCH 	/* PE18 gpio CD pin pull up and deglitch */
 							 AT91_PIOE 19 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP>;	/* PE19 gpio WP pin pull up */
-- 
2.12.0


_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux