This property is needed for barebox or may be other bootloaders
to set proper gpio configuration as early as possible.
This example is mainly based on "lines-initial-states" property
from this binding documentation:
Documentation/devicetree/bindings/gpio/gpio-pcf857x.txt
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/gpio/gpio.txt | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/Documentation/devicetree/bindings/gpio/gpio.txt b/Documentation/devicetree/bindings/gpio/gpio.txt
index 84ede036f73d..60f8e8d8ab32 100644
--- a/Documentation/devicetree/bindings/gpio/gpio.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio.txt
@@ -181,6 +181,26 @@ gpio-controller@00000000 {
"poweroff", "reset";
}
+Optionally, a GPIO controller may have a "gpio-lines-initial-states" property.
+This is an array of values that specifies the initial state of each line. When
+a value is set to one, the corresponding line will be initialized to the input
+(pulled-up) state. When the values is set to two, the line will be initialized
+the low-level output state. If values is set to zero the line will be
+initialized to the input state.
+If the property is not specified no specific configuration will be set. Driver
+should reuse HW configuration provided by bootloader or other system.
+
+Example:
+
+gpio-controller@00000000 {
+ compatible = "foo";
+ reg = <0x00000000 0x1000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ ngpios = <9>;
+ gpio-lines-initial-states = <0>, <1>, <2>, <0>, <0>, <2>, <2>, <1>, <1>;
+}
+
The GPIO chip may contain GPIO hog definitions. GPIO hogging is a mechanism
providing automatic GPIO request and configuration as part of the
gpio-controller's driver probe function.
--
2.11.0
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
