Since commit 823d08e3e261 ("kwbimage_v1: add support to boot a mvebu image") barebox can use bootm to load a 2nd barebox image. Update the documentation accordingly. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx> --- Documentation/boards/mvebu.rst | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/boards/mvebu.rst b/Documentation/boards/mvebu.rst index b4f8e6043dac..4dfdc4a8f761 100644 --- a/Documentation/boards/mvebu.rst +++ b/Documentation/boards/mvebu.rst @@ -28,8 +28,8 @@ initialisation that could be taken. Booting second stage -------------------- -This is currently not possible because barebox assumes the registers are mapped -at 0xd0000000 as is the case when the boot ROM gives control to the bootloader. +Since ``v2017.04.0`` barebox can boot a barebox image even if the register +window is moved. This is implemented by writing the actual window position into the image where it is then picked up by the second stage bootloader. Booting from UART ----------------- -- 2.11.0 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox