Hello,
I was looking around to have a common Barebox binary to bootup two
boards based on iMX6 SoC.
The PCB are at 99.8% the same.
PCB#0 has iMX6QP and a VDDCore of 1.38V (LDO enabled)
PCB#1 has iMX6DL and a VDDCore of 1.32V (LDO enabled)
I was wondering how other boards (like Nitrogen6x) does for booting.
As soon as my boards have the same DDR Memory routing and types, the oly
thing I can think is the different memory address space for DDR controller.
In fact, the Nitrogen6x boards, differs from the #include of the ddr
controller (one is for dual-lite, the other for quad).
But I do not found any switch between choosing one Soc or another.
Where is done the startup entry?
And the maximum clock speed??? Those SoC has different clock maximum
speed, so I think someone has to tell it to run @800 Mhz or @1Ghz. Is
this true?
Are those stuff the only things that matters?
Regards,
--
Eurek s.r.l. |
Electronic Engineering | http://www.eurek.it
via Celletta 8/B, 40026 Imola, Italy | Phone: +39-(0)542-609120
p.iva 00690621206 - c.f. 04020030377 | Fax: +39-(0)542-609212
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
