Instead of using gpio_is_valid just check the return code of of_get_gpio
for being < 0. This fixes -EPROBE_DEFER handling as now this error code
is handed to the caller instead of -ENODEV. If the gpio returned by
of_get_gpio is an invalid number this isn't noticed by
of_i2c_gpio_probe, but then gpio_request later fails which is good
enough.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
---
drivers/i2c/busses/i2c-gpio.c | 16 +++++++++-------
1 file changed, 9 insertions(+), 7 deletions(-)
diff --git a/drivers/i2c/busses/i2c-gpio.c b/drivers/i2c/busses/i2c-gpio.c
index 9362ed181fe3..850db7b2f652 100644
--- a/drivers/i2c/busses/i2c-gpio.c
+++ b/drivers/i2c/busses/i2c-gpio.c
@@ -89,6 +89,7 @@ static int of_i2c_gpio_probe(struct device_node *np,
struct i2c_gpio_platform_data *pdata)
{
u32 reg;
+ int ret;
if (!IS_ENABLED(CONFIG_OFDEVICE))
return -ENODEV;
@@ -96,14 +97,15 @@ static int of_i2c_gpio_probe(struct device_node *np,
if (of_gpio_count(np) < 2)
return -ENODEV;
- pdata->sda_pin = of_get_gpio(np, 0);
- pdata->scl_pin = of_get_gpio(np, 1);
+ ret = of_get_gpio(np, 0);
+ if (ret < 0)
+ return ret;
+ pdata->sda_pin = ret;
- if (!gpio_is_valid(pdata->sda_pin) || !gpio_is_valid(pdata->scl_pin)) {
- pr_err("%s: invalid GPIO pins, sda=%d/scl=%d\n",
- np->full_name, pdata->sda_pin, pdata->scl_pin);
- return -ENODEV;
- }
+ ret = of_get_gpio(np, 1);
+ if (ret < 0)
+ return ret;
+ pdata->scl_pin = ret;
of_property_read_u32(np, "i2c-gpio,delay-us", &pdata->udelay);
--
2.10.2
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
