Hello Juerguen, I was looking to buy an ARM9 Jtag because it's what I though... I would need a JTAG. Regarding shorting the data lines... do you know exactly what would I need to do? Regarding JTAG, which ones are the steps? Thank you so much 2016-10-21 9:39 GMT+02:00 Juergen Borleis <jbe@xxxxxxxxxxxxxx>: > Hi Javier, > > On Thursday 20 October 2016 19:59:54 Javier Fileiv wrote: >> ups... I think Ive broken everything... I just put at the end of the >> env/config file "boot nand" and now is looping and at some point it >> says "ERROR: out of memory". >> Another thing... I changed vivibootloader in NOR for the barebox, and >> even if I change to NOR it's looping again and again... What do I do? >> HELP! > > Seems you configured your board into a brick. You now can boot from NOR and > short some data lines pins at the NAND device to make barebox fail to read its > environment from NAND and fall back to the built-in default environment > without that loop. > Or you need some JTAG equipment to make the SoC working again. > > Cheers, > Juergen > > -- > Pengutronix e.K. | Juergen Borleis | > Industrial Linux Solutions | http://www.pengutronix.de/ | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox