Hello Juergen, Here is my power up output, thanks you very much Terminal ready barebox 2011.05.0-ptx-2014.11.0 (Oct 13 2016 - 21:53:08) Board: Mini 2440 NAND device: Manufacturer ID: 0xec, Chip ID: 0xd3 (Samsung NAND 1GiB 3,3V 8-bit) Bad block table found at page 524224, version 0x01 Bad block table found at page 524160, version 0x01 nand_read_bbt: Bad block at 0x255a0000 dm9000 i/o: 0x20000300, id: 0x90000a46 eth@eth0: got MAC address from EEPROM: 00:00:00:00:00:00 cfi_probe: cfi_flash base: 0x00000000 size: 0x00200000 ## Unknown FLASH on Bank at 0x00000000 - Size = 0x00000000 = 0 MB refclk: 12000 kHz mpll: 405000 kHz upll: 48000 kHz fclk: 405000 kHz hclk: 101250 kHz pclk: 50625 kHz SDRAM1: CL2@101MHz Malloc space: 0x33a00000 -> 0x33e00000 (size 4 MB) Stack space : 0x339f8000 -> 0x33a00000 (size 32 kB) running /env/bin/init... 2016-10-19 9:53 GMT+02:00 Juergen Borleis <jbe@xxxxxxxxxxxxxx>: > Hi Javier, > > On Tuesday 18 October 2016 18:56:03 Javier Fileiv wrote: >> Trying to autoboot from nand, I set my /env/config file like that (and >> after that a "saveenv"). Although it doesn't work automaGically! :) > > Can you also send the output of barebox from power on up to the point it falls > into the prompt? > > Cheers, > Juergen > > -- > Pengutronix e.K. | Juergen Borleis | > Industrial Linux Solutions | http://www.pengutronix.de/ | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
