Hi Alexander, On Fri, May 20, 2016 at 11:09:06AM +0300, Alexander Shiyan wrote: > Hello. > > Patch 05261801e9cde103b3c4df843472027c007531da changes input subsystem. > If the CONFIG_CONSOLE_ACTIVATE_FIRST is set and barebox config contain > one serial console and one input device (GPIO buttons, for example), the console stops working. > Currently I haven't found a solution for this, but the CONFIG_CONSOLE_ACTIVATE_ALL > solve the problem. The GPIO buttons is registered at device_initcall time whereas the UART console devices are normally registered at console_initcall time. I assume either your UART driver or the corresponding device is registered from a device_initcall when it should be from console_initcall. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
