First of all the reset values of MMC interfaces are differently between
Quad and DualLite/Solo SoM.
Register VEND_SPEC2(0xC8)
Quad: 0x0
DualLite: 0x00000006
default: 0x00000006 (from i.MX6 Reference Manual)
Furthermore the ROM Code of Quad and DualLite uses the MMC interfaces
differently when it loads the bootloader from that device:
Register DLL_CTRL(0x60) Bit 25 FBCLK_SEL (0x48)
Quad: 0x0 0
DualLite: 0x01000021 1
Since the linux kernel and barebox driver doesn't reset all registers,
the MMC interface is in an inconsistent state, which leads to boot
failures for some eMMC devices on the i.MX6 DualLite SoM. The errors
look like:
mmcblk3: error -110 sending stop command, original cmd response 0x900, card status 0x400900
mmcblk3: error -84 transferring data, sector 24578, nr 2, cmd response 0x900, card status 0x0
mmcblk3: retrying using single block read
mmcblk3: error -84 transferring data, sector 24578, nr 2, cmd response 0x900, card status 0x0
blk_update_request: I/O error, dev mmcblk3, sector 24578
It's sufficient to reset register DLL_CTRL and bit FBCLK_SEL. Register
VEND_SPEC2 has no effect.
Signed-off-by: Stefan Christ <s.christ@xxxxxxxxx>
---
v2: send patch again with charset 'utf8', not 'y'. Sorry.
---
drivers/mci/imx-esdhc.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/mci/imx-esdhc.c b/drivers/mci/imx-esdhc.c
index 282887b..2e189fe 100644
--- a/drivers/mci/imx-esdhc.c
+++ b/drivers/mci/imx-esdhc.c
@@ -41,6 +41,8 @@
#define IMX_SDHCI_WML 0x44
#define IMX_SDHCI_MIXCTRL 0x48
+#define IMX_SDHCI_DLL_CTRL 0x60
+#define IMX_SDHCI_MIX_CTRL_FBCLK_SEL (BIT(25))
struct fsl_esdhc_host {
struct mci_host mci;
@@ -516,11 +518,23 @@ static int esdhc_reset(struct fsl_esdhc_host *host)
{
void __iomem *regs = host->regs;
uint64_t start;
+ int val;
/* reset the controller */
esdhc_write32(regs + SDHCI_CLOCK_CONTROL__TIMEOUT_CONTROL__SOFTWARE_RESET,
SYSCTL_RSTA);
+ /* extra register reset for i.MX6 Solo/DualLite */
+ if (cpu_is_mx6()) {
+ /* reset bit FBCLK_SEL */
+ val = esdhc_read32(regs + IMX_SDHCI_MIXCTRL);
+ val &= ~IMX_SDHCI_MIX_CTRL_FBCLK_SEL;
+ esdhc_write32(regs + IMX_SDHCI_MIXCTRL, val);
+
+ /* reset delay line settings in IMX_SDHCI_DLL_CTRL */
+ esdhc_write32(regs + IMX_SDHCI_DLL_CTRL, 0x0);
+ }
+
start = get_time_ns();
/* hardware clears the bit when it is done */
while (1) {
--
1.9.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
