Empirical observations show that configuring INTCN=1, ECLK=0, EGFIL=0,
DOSF=1 on DS1341 put the chip in the mode where it draws the least
amount fo current.
Add code to configure DS1341 in such a way in case Barebox is the last
code that runs on the processor before being shut down.
Signed-off-by: Andrey Smirnov <andrew.smirnov@xxxxxxxxx>
---
drivers/rtc/rtc-ds1307.c | 20 ++++++++++++++++----
1 file changed, 16 insertions(+), 4 deletions(-)
diff --git a/drivers/rtc/rtc-ds1307.c b/drivers/rtc/rtc-ds1307.c
index a1cfed6..4720964 100644
--- a/drivers/rtc/rtc-ds1307.c
+++ b/drivers/rtc/rtc-ds1307.c
@@ -68,6 +68,7 @@ enum ds_type {
#define DS1337_REG_CONTROL 0x0e
# define DS1337_BIT_nEOSC 0x80
# define DS1339_BIT_BBSQI 0x20
+# define DS1341_BIT_EGFIL 0x20
# define DS3231_BIT_BBSQW 0x40 /* same as BBSQI */
# define DS1337_BIT_RS2 0x10
# define DS1337_BIT_RS1 0x08
@@ -83,6 +84,7 @@ enum ds_type {
# define DS1340_BIT_OSF 0x80
#define DS1337_REG_STATUS 0x0f
# define DS1337_BIT_OSF 0x80
+# define DS1341_BIT_DOSF 0x40
# define DS1341_BIT_ECLK 0x04
# define DS1337_BIT_A2I 0x02
# define DS1337_BIT_A1I 0x01
@@ -333,12 +335,22 @@ static int ds1307_probe(struct device_d *dev)
i2c_smbus_write_byte_data(client, DS1337_REG_CONTROL,
ds1307->regs[0]);
- /*
- For the above to be true, DS1341 also has to have
- ECLK bit set to 0
- */
if (ds1307->type == ds_1341) {
+ /*
+ For the above to be true, DS1341 also has to have
+ ECLK bit set to 0
+ */
ds1307->regs[1] &= ~DS1341_BIT_ECLK;
+
+ /*
+ * Let's set additionale RTC bits to
+ * facilitate maximum power saving.
+ */
+ ds1307->regs[0] |= DS1341_BIT_DOSF;
+ ds1307->regs[0] &= ~DS1341_BIT_EGFIL;
+
+ i2c_smbus_write_byte_data(client, DS1337_REG_CONTROL,
+ ds1307->regs[0]);
i2c_smbus_write_byte_data(client, DS1337_REG_STATUS,
ds1307->regs[1]);
}
--
2.5.5
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
