Signed-off-by: Antony Pavlov <antonynpavlov@xxxxxxxxx> --- .../boards/black-swift/include/board/board_pbl_start.h | 6 ++++++ arch/mips/dts/black-swift.dts | 15 +++++++++++++++ 2 files changed, 21 insertions(+) diff --git a/arch/mips/boards/black-swift/include/board/board_pbl_start.h b/arch/mips/boards/black-swift/include/board/board_pbl_start.h index 0d68004..ee21a85 100644 --- a/arch/mips/boards/black-swift/include/board/board_pbl_start.h +++ b/arch/mips/boards/black-swift/include/board/board_pbl_start.h @@ -46,6 +46,12 @@ skip_pll_ram_config: debug_ll_ar9331_init mips_nmon + /* + * It is amazing but we have to enable MDIO on GPIO + * to use GPIO27 for LED1. + */ + pbl_ar9331_mdio_gpio_enable + copy_to_link_location pbl_start .set pop diff --git a/arch/mips/dts/black-swift.dts b/arch/mips/dts/black-swift.dts index 270374d..b0fa3b0 100644 --- a/arch/mips/dts/black-swift.dts +++ b/arch/mips/dts/black-swift.dts @@ -1,6 +1,7 @@ /dts-v1/; #include "ar9331.dtsi" +#include <dt-bindings/gpio/gpio.h> / { model = "Black Swift"; @@ -13,12 +14,26 @@ aliases { spiflash = &spiflash; }; + + leds { + compatible = "gpio-leds"; + + s1 { + label = "LED1"; + gpios = <&gpio 27 GPIO_ACTIVE_LOW>; + default-state = "off"; + }; + }; }; &serial0 { status = "okay"; }; +&gpio { + status = "okay"; +}; + &spi { num-chipselects = <1>; status = "okay"; -- 2.7.0 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox