Hi All, I am trying to use Barebox on Terasic's SoCKit board and so far I've had limited success. My sequence of actions is the following: 1. Get zImage, device tree file and .rbf file from a pre-built image available here: http://www.rocketboards.org/foswiki/Documentation/ArrowSoCKITEvaluationBoard140LinuxGettingStarted 2. Boot into barebox 3. cp /boot/soc_system.rbf /dev/socfpga-fpga (This step initially didn't work for me, so I had to make a change to the firmware driver http://lists.infradead.org/pipermail/barebox/2015-April/023194.html) 4. global.linux.bootargs.base="console=ttyS0,115200" 5. global.bootm.oftree=/boot/soc_system.dtb 6. global.bootm.image=/boot/zImage 7. bootm After the last step I and barebox jumps to the kernel code I don't see any output on the serial at all. I feel like I am missing something obvious, but I can't figure out what it is. If anyone has had experience booting Linux using barebox on aforementioned board I'd greatly appreciate to hear about how you did it. Thank you, Andrey Smirnov _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
