Good morning, I am currently trying to build the MLO for the omap4460 on a Phytec Phycore board. In order to build it, I do the following procedure, but I get this size error at the end: > make ARCH=arm CROSS_COMPILE=... phytec-phycore-omap4460-xload_defconfig > make .... LD barebox SYSMAP System.map OBJCOPY barebox.bin CHKSIZE barebox.bin barebox.bin size 53168 > of the maximum size 49152 make: *** [barebox.bin] Error 1 Curiously enough, the MLO is bigger than the 2nd stage barebox.bin I would generate with the config phytec-phycore-omap4460_defconfig. In the documentation (boards/omap.rst), there is mention of a "barebox.bin.ift" file that corresponds to the MLO. However I don't have this file...only barebox and barebox.bin. Is my build procedure correct ? _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
