Hi Steffen, On Fri, 09 Jan 2015 10:07:54 +0100 Steffen Trumtrar <s.trumtrar@xxxxxxxxxxxxxx> wrote: > > Hi! > > Masahiro Yamada writes: > > Hello Steffen Trumtrar, > > > > I am seeing arch/arm/boards/avnet-zedboard/board.c > > written by you. > > > > Sadly it's been a while since I touched this :( > > > Is this file equivalent to ps7_init.c spit by Xilinx tool? > > Or did you write it by hand from scratch ? (I doubt it.) > > > > > > I have ZC706, another Zynq board. > > If I could port barebox to this board, that would be great! > > But I am just worndering whether I could get your advice about > > how to create the lowlevel file. > > > > The lowlevel.c/flash_header.c are adapted from the ps7_init code IIRC. > Xilinx uses a prebootloader and a bootloader for the Zynq, barebox does > not. So you would have to put all values into the respective two files. > And you need to run scripts/zynq_mkimage for the checksum (but I think > the Makefile already does that). > > I wish I could be of more help here, but I can't really remember the > actual steps necessary and I don't have a ps7_init handy at the moment. > OK, thanks. I just wanted to be sure in case there were some tools or tips etc. that would save my time. Anyway, I will give it a try. Best Regards Masahiro Yamada _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
