Hello, I have read the documentation but I believe it to be out of date, as it does not match up with the source from the git tree. To that end, I am trying to add a new board, and I can not figure out how to do so. My board uses the mx27 processor, and so I am attempting to closely mimic one of the other mx27 boards, when following the steps here: http://barebox.org/documentation/barebox-2011.05.0/dev_board.html I find the following inconsistencies: 1. include/configs/<boardname>.h - the configs directory does not exist. 2. modify arch/<architecture>/Kconfig - add your board (MACH_*) to the list - add your default text base address for this architecture (ARCH_TEXT_BASE) - add BOARDINFO with valueable info for your board None of this exists. 3. modify arch/<architecture>/Makefile: - add board-$(MACH_*) = <your board_dir> This does not exist And my board will not show up in the menu config. Also I am finding it difficult to locate where I set things like flash size, ram size, etc... u-boot has a much simpler (if not less documented) layout when it came to boards. Alas I can not use u-boot, because of the nand flash limitations, and thus why I am attempting to use barebox. And finally there seems to be some confusiton both in the code and the documentation about the difference between a board and a machine. What is the difference? I'm sorry that there is a lot here, but I can not find the proper documentation to answer these questions. Also, for those that are curious, or can help me get around this issue. I attempting to get this going on a board with an mx27 booted from NAND flash, so I believe I have to use the PBL option to setup and copy out of nand to do the real booting. If there is any advice on this, I would appreciate it. I have no other bootloader, only bare metal and a JTAG device. thank you. _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
