On 15:44 Tue 02 Oct , Renaud Barbier wrote: > On 24/09/12 10:31, Jean-Christophe PLAGNIOL-VILLARD wrote: > > > > > Adapt phylib from linux > > > > This will allow to have > > - phy drivers > > - to only connect the phy at then opening of the device > > - if the phy is not ready or down fail on open > > > > Same behaviour as in linux and will allow to share code and simplify porting. > > > > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@xxxxxxxxxxxx> > > > > ---------------------------------------------------------------- > > Jean-Christophe PLAGNIOL-VILLARD (1): > > net: introduce phylib > > > > arch/arm/boards/freescale-mx6-arm2/board.c | 43 ++--- > > arch/arm/boards/freescale-mx6-sabrelite/board.c | 40 ++-- > > arch/arm/configs/phycard_a_l1_defconfig | 2 +- > > arch/arm/configs/tx51stk5_defconfig | 2 +- > > arch/ppc/boards/pcm030/pcm030.c | 4 +- > > arch/ppc/mach-mpc5xxx/include/mach/fec.h | 14 -- > > drivers/net/Kconfig | 30 +-- > > drivers/net/Makefile | 2 +- > > drivers/net/altera_tse.c | 48 +++-- > > drivers/net/altera_tse.h | 3 +- > > drivers/net/at91_ether.c | 49 ++--- > > drivers/net/designware.c | 62 ++++--- > > drivers/net/dm9k.c | 50 +++-- > > drivers/net/ep93xx.c | 35 ++-- > > drivers/net/ep93xx.h | 2 +- > > drivers/net/fec_imx.c | 89 +++++---- > > drivers/net/fec_imx.h | 6 +- > > drivers/net/fec_mpc5200.c | 58 +++--- > > drivers/net/fec_mpc5200.h | 4 +- > > drivers/net/gianfar.c | 61 +++--- > The mdiobus_scan performed when registering the mdio bus at probe time > has an impact on boot time. I have a 85xx board whose PHY needs 450ms to > be ready for access. > > I will send a patch for the gianfar driver to register the mdio bus only > when the device is open. That why I did at the first open before and I guess your case is not the only one I do not like the idea to register the bus later we need to have defer probe Best Regards, J. _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
