On Sun, Sep 16, 2012 at 07:54:58PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> Adapt phylib from linux
>
> switch all the driver to it
>
> This will allow to have
> - phy drivers
> - to only connect the phy at then opening of the device
> - if the phy is not ready or not up fail on open
>
> Same behaviour as in linux and will allow to share code and simplify porting.
>
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@xxxxxxxxxxxx>
> +/* Automatically gets and returns the PHY device */
> +int phy_device_connect(struct mii_device *bus, int addr,
> + void (*adjust_link) (struct eth_device *edev),
> + u32 flags, phy_interface_t interface)
> +{
> + struct eth_device *edev = bus->edev;
You should pass in a struct eth_device pointer here instead of getting
it from bus->edev because a struct mii_device can have multiple ethernet
devices. The next step would be to remove the edev member from struct
mii_dev and add it to struct phy_device insted.
BTW no typedefs please. Use enum phy_interface instead.
Sascha
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
