Re: USB On PCM043?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jul 19, 2012 at 03:37:47PM +0000, Jerry Kirk wrote:
> We have been attempting to get USB Host mode working under Barebox(2012-07-0) on 
> a PCM043 platform (i.mx35), but we are having a bit of trouble.
> 
> We have  merged the CONFIG_USB specific code for "imx35_devices_init" and 
> "imx35_usb_init" from the Eukrea platform into pcm043.c, added the 
> "MX35_PAD_I2C2_CLK__USB_TOP_USBH2_PWR" and "MX35_PAD_I2C2_DAT__USB_TOP_USBH2_OC" 
> pad definitions (as per the main kernel pcm043.c file), added the "tmp |= 0x3 << 
> CCM_CGR2_USB_SHIFT" to enable the USB clock to "pcm043_core_setup", built 
> everything with the "usb" command enabled, and then loaded the new Barebox image 
> into our pcm043 board. We have USB_EHCI and USB_STORAGE enabled in the Barebox 
> config.
> 
> If I execute the "usb" command then it returns that it has found 1 EHCI 
> controller. If I plug in any device, the only one it has EVER detected has been 
> a USB mouse. It will be detected most of the time following a reset and after 
> unplugging/replugging the mouse -- but will never be detected again after this 
> unless I do a reset/replug operation (and never on a "usb -f" forced redetect).
> 
> Basically, our goal is to get USB flash drives working for use as a means of 
> upgrading our Linux kernel in the field -- but right now it won't even EVER 
> recognize a USB flash drive when it is plugged into the unit. We also know it is 
> not a hardware problem as all USB devices work just fine once the full kernel 
> finishes booting.
> 
> From what we have read, it looks like the Eukrea platform had USB working in it, 
> and we have attempted to use it as a guide, but we still aren't having any luck.
> 
> Does anyone know of any steps we might be missing? Or of anyone who has gotten 
> USB host mode working on a pcm043 under Barebox before?
> 
> I think we are close, but something (obviously) still isn't right.

Could it be that the USB clock operates at the wrong rate? I think it
should be 60MHz.

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |

_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox


[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux