> I flashed from 0x0 to 0x7FFFF (image size: 479K). > I flashed the environment image (image size: 3K) from 0x80000 to 0xFFFFF > and changed the config code from barebox/environs/common/config to: > > ... > nand_parts="512k(barebox)ro,768k(bareboxenv),4M(kernel),120M(root)" > ... > > Barebox can boot now but the startup log says: > barebox 2012.03.0-dirty (Jul 16 2012 - 09:01:01) > > Board: i.MX53 > eth@eth0: got MAC address from EEPROM: ********************* > nand_get_flash_type: second ID read did not match ef,ef against c0,c0 > No NAND device found (-19)! > Malloc space: 0x7df00000 -> 0x7fefffff (size 32 MB) > Stack space : 0x7def8000 -> 0x7df00000 (size 32 kB) > Open /dev/env0 No such file or directory > running /env/bin/init... > not found > barebox:/ > > How can i get the environment loaded? Normally you would issue 'saveenv' which writes the environment to the environment partition. On subsequent boots the environment will be loaded. But the flash device on your board isn't detected by barebox, so you will have to fix the detection first. > nand_get_flash_type: second ID read did not match ef,ef against c0,c0 This line suggests, that the nand flash isn't working property. The line is generated in drivers/mtd/nand/nand_base.c, after reading manufacturer id and chip id two times, and checking them for equality. Not only does your board different values for manufacturer and flash id on first and second read, but they are also the same. manuf id=ef and chip id=ef isn't plausible. Maybe you should check your hardware. Regards Christian _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
