Hello. Thu, 17 May 2012 12:27:50 +0200 от Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>: > On Tue, May 15, 2012 at 10:47:54PM +0400, Alexander Shiyan wrote: > > Added support for CompactFlash cards for PCM970 development board via > > PCMCIA window. Directly we cannot use this feature, because some signals > > connects to i.MX pins which cannot be configured as GPIO. This is first > > try to make this interface works, so comments are welcome. > What do you mean with "Directly we cannot use this feature"? I mean work directly on the address and data bus or via PCMCIA, as meant to be, in the True IDE mode. It was possible to run only in this mode by using some PCMCIA pins as GPIO. > > Hit any key to stop autoboot: 3 > > barebox@Phytec phyCORE-i.MX27:/ mkdir /d > > barebox@Phytec phyCORE-i.MX27:/ mount /dev/disk0.0 fat /d > > barebox@Phytec phyCORE-i.MX27:/ ls /d > > test.txt > It seems to work fine here? Yes, but if necessary I can do more thorough tests: writing, load kernel image etc. _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
