On Thu, Apr 05, 2012 at 11:40:49AM +0200, Patrick wrote:
> Dear mailing-list,
>
> I am using a pcm049 phyCORE omap4430 module from Phytec with BareBox
> 2011.09.0 patched with BSP from Phytec.
>
> I would like to use the GPIO command to read a switch at startup.
> This chip is connected on ABE_MCBSP1_DX (gpio_116). I have edited
> the boards/pcm049/mux.c files to change the configuration of this
> GPIO as follow: {ABE_MCBSP1_DX, (DIS | IEN | M3)} instead of
> {ABE_MCBSP1_DX, (SAFE_MODE)}.
>
> I then use the "gpio_get_value 116" command followed by "echo $?" to
> read the value. I always read a 0. On Linux I could read the right
> value depending of the position of the switch, so it's not an
> hardware problems.
>
> I have tried with one of the two LEDs on the module (gpio_152) and I
> could change the LED state and read it back with gpio_get_value.
>
> I do not understand what I am doing wrong. Any help will be appreciated.
What you tried should work. The only thing I can imagine is that you
need a gpio_direction_input before reading the value.
Sascha
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
