I have some problems. May you please send me a binary produced with this tool?
I want to inspect the flash header.
-- Gebhardt
Von: Matthias Fend <Matthias.Fend@xxxxxxxxxxxxxx>
An: "guenter.gebhardt@xxxxxxx" <guenter.gebhardt@xxxxxxx>, "barebox@xxxxxxxxxxxxxxxxxxx" <barebox@xxxxxxxxxxxxxxxxxxx>
Datum: 26.03.2012 11:09
Betreff: AW: imx53 internal boot from NAND
Hi,
For a quick start you can use the provided FCB (fcb.bin).
This FCB was generated with the attached tool (fcbgen.c) - note that the bad block handling is disabled.
Then you can "merge" your barebox image with the FCB with something like:
cat fcb.bin barebox-image > barebox-fcb.bin
This works at least on our custom i.MX53 hardware.
~Matthias
Von: barebox-bounces@xxxxxxxxxxxxxxxxxxx [mailto:barebox-bounces@xxxxxxxxxxxxxxxxxxx] Im Auftrag von guenter.gebhardt@xxxxxxx
Gesendet: Montag, 26. März 2012 10:48
An: barebox@xxxxxxxxxxxxxxxxxxx
Betreff: imx53 internal boot from NAND
Hello,
I tried to use barebox in order to boot from NAND.
The ROM loader needs a FCB (Firmware Configuration Block) table at the beginning of the flash (according to chapter 7.5.2.2 of the reference manual).
I looked at the existing imx53 boards within the barebox sources but I founx that no one used this mode there.
Has someone done this or can give me some advice?
-- Gebhardt
[Anhang "fcbgen.c" gelöscht von Guenter Gebhardt/Rafi] [Anhang "fcb.bin" gelöscht von Guenter Gebhardt/Rafi]
_______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
